Rock-slide-engineering JEEP JK2 STEP SLIDER Uživatelský manuál stáhnout pdf

Installation Instruction RSEI 107

JEEP JK2 STEP SLIDER INSTALLATION

BD-SS-100-JK2

1 2 3 4 5 6 7 8 9

Installation Instruction RSEI 107 JEEP JK2 STEP SLIDER INSTALLATION BD-SS-100-JK2

Installation Instruction RSEI 107 PARTS LIST QTY DESCRIPTION 1 Drivers Side Slider Assembly 1 Passenger Side Slider Assembly 1 Wiring Harness and F

Installation Instruction RSEI 107 STEP SLIDER INSTALLATION 1. Remove the stock rocker guard if equipped. 2. Move the slider into position on the Je

Installation Instruction RSEI 107 8. Lift the slider back into position and attach it to the Jeep using the 5/16” button head bolts and 5/16” washers

Installation Instruction RSEI 107 WIRING HARNESS INSTALL **Note: The same harness is used for the JK 4-door version ** The additional door sensors a

Installation Instruction RSEI 107 5. Once the harness is positioned in its proposed layout you will need to gain access to the slider outside the Jee

Installation Instruction RSEI 107 12. Remove the driver side dash panel and drill a 18mm hole in the panel to accommodate the cutoff switch. a. You

Installation Instruction RSEI 107 a. Make sure the actuating magnets are in perfect line with the sensors b. **DO NOT allow the magnet and sensor

Installation Instruction RSEI 107 TROUBLE SHOOTING/FRICTION POINTS  The slider is powered by the Jeep’s battery when engine is off and powered b

Žádné komentáře

Rock-slide-engineering JEEP JK2 STEP SLIDER Uživatelský manuál