Rock-slide-engineering RAM STEP SLIDER Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Rock-slide-engineering RAM STEP SLIDER. Rock-Slide Engineering RAM STEP SLIDER User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 13
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Installation Instruction RSEI 108
Ram Step Slider Installation
BD-SS-100-RAM, .BD-SS-101-RAM
Zobrazit stránku 0
1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1

Installation Instruction RSEI 108 Ram Step Slider Installation BD-SS-100-RAM, .BD-SS-101-RAM

Strany 2 - STEP SLIDER INSTALLATION

Installation Instruction RSEI 108 a. Pull the rubber door seal away from near the latch and run the sensor wires u

Strany 3 - Remove plastic

Installation Instruction RSEI 108 THE BRASS COLORED PRONG IS FOR THE GROUND THE SILVER C

Strany 4

Installation Instruction RSEI 108 20. Position the actuating magnets on the catch side of each do

Strany 5

Installation Instruction RSEI 108 TROUBLE SHOOTING/FRICTION POINTS  The slider is powered by the truck’s battery when engine is off and power

Strany 6

Installation Instruction RSEI 108 PARTS LIST

Strany 7

Installation Instruction RSEI 108 1. Remove the black rubber pieces covering the factory mounting holes on the bottom and back of the cab pinch s

Strany 8 - **WARNING**

Installation Instruction RSEI 108 5. Hold the bracket up against the truck panel matching the body angles. Position the bracket so that the

Strany 9

Installation Instruction RSEI 108 8. Install the back bracket 9. Line up the bracket holes to the matching factory holes 10. Bolt the bra

Strany 10 - Door sensor installed

Installation Instruction RSEI 108 16. Mak

Strany 11 - Recommended

Installation Instruction RSEI 108 20. Bolt the bottom of the bracket into the step slider body with a 7/16” bolt and washer. Tighten the bolt int

Strany 12

Installation Instruction RSEI 108 Step Slider Wiring Diagram Driver Side Wire Color Passenger Side Wire Color Front Door Sensor Oran

Strany 13

Installation Instruction RSEI 108 2. Lay out the wiring harness on the carpet in the back seat 3. Split the harne

Komentáře k této Příručce

Žádné komentáře